User's Manual

Ubee Interactive — www.ubeeinteractive.com
3 Ubee DVW325 – Safety and Installation Product Insert v1.0
chemical cleaners.
6. Avoid static discharge when touching
the device by first touching the
coaxial connector of the coaxial
cable.
7. Installation of the device should
include grounding the coaxial cable
to the earth at the building entrance
per ANSI/NFPA 70 and the National
Electrical Code (NEC, in particular,
Section 820.93, Grounding of the
Outer Conductive Shield of a Coaxial
Cable). The device is designed for IT
power systems with phase-to-phase
voltage at 120-240V.
8. Disconnecting the Device: If the
device becomes damaged or
encounters some other abnormality,
disconnect the power plug from the
AC wall outlet immediately.
9. The device should be installed in a
location not to exceed the maximum
temperature of 40 degrees Celsius
(104 degrees Fahrenheit).
10. When this device is placed upright
with the aid of the stand, the stand
must be fixed at a 90 degree angle to
the device. Otherwise, the device will
have the risk of tipping over.
Installation
To install this device, follow the procedures
below and refer to the following page for a
connection diagram.
1. Connect one end of a coaxial cable (not
included) to the CABLE port on the device.
Connect the other end to a cable splitter or
the cable wall outlet. Be sure not to bend or
over tighten the cables as this may strain
the connector and cause damage. If you
plan to connect the device and a television
to the same cable wall outlet, you must use
a cable line splitter (not included).