User's Manual

Ubee Interactive — www.ubeeinteractive.com
6 Ubee DVW325 – Safety and Installation Product Insert v1.0
Additional Information
1. RESET Button (back of device): This
button resets the device to factory defaults.
Using a pointed object, insert it into the
button opening, and hold for more than 10
seconds. The device will reset and reboot.
Note: Not all parameters are reset to
factory defaults. Refer to the User Guide
for more information.
2. Battery (bottom of device): A slot is
provided that houses the battery and can
be opened/closed for battery insertion or
replacement.
3. WPS button (top of device): The WPS
button is used for the Wi-Fi Protected
Setup (WPS) method to connect a Wi-Fi
device to the DEVICE. Refer to the User
Manual for more information.
4. USB Connector (back of device): If the
USB connector is supported and enabled
by the service provider, some USB devices
can be connected here, such as computers,
flash drives, etc.
LEDs and Other Device Indicators
See the following diagram and descriptions of the
device’s LED behavior, and the behavior of the
back-panel Ethernet indicators.
LED Indicators (Color = Green When On):
Power—If On, indicates that the device has
successfully completed internal power-on tests.
LED flashes if power-on fails. Note that the LED
flashes briefly immediately after powering the
device.