User's Manual

Ubee Interactive — www.ubeeinteractive.com
7 Ubee DVW325 – Safety and Installation Product Insert v1.0
US/DS—When the device initializes, the LED
flashes. When the device locks on to channels
and registers OK, the LED is On. When the
device performs a firmware upgrade, the LED
flashes.
On-line—When the device is obtaining an IP
address and configuration file, the LED flashes.
When device obtains these items, the LED is On.
Wi-Fi—When Wi-Fi is enabled, the LED is On.
When Wi-Fi is disabled, the LED is Off.
Tel 1/Tel 2—The LED is On when a telephone is
on-hook. The LED flashes when a telephone is
off-hook.
Battery—LED is On when the battery is installed
and charged. LED is Off if no battery is installed.
If the battery is at low power level (30mins left),
the battery LED will flash.
WPS (top of device)—If not used, the LED is Off.
When the user pushes the WPS button or
triggers WPS via the device’s web GUI, the LED
flashes blue for 4 minutes until a PIN is entered
from a wireless client that wishes to connect.
After a Wi-Fi client attaches successfully, the
LED remains solid Blue for 5 minutes, and then
turns green.
Back Panel Ethernet Indicators
(Color = Orange or Green):
 When an Ethernet device, such as a
computer, is connected to the device, the
LED is Orange when connected at 10/100
Mbps speeds.
 When an Ethernet device, such as a
computer, is connected to the device, the
LED is Green when connected at
1000 Mbps speeds (Gigabit Ethernet).
 When data is being passed between the
device and the connected device, the LED
flashes.