Quick Installation Guide

•

DEVICE WALL MOUNT INSTRUCTIONS

Label

Millimeters

(mm)

7.2 +/- 0.5

2.6 +/- 0.15

19.0 +/- 1.2

3~4

UBC1319AA00 Quick Installation Guide

5. Separate the wall mounting pieces. Mount the top and

bottom leg stand pieces (Figure 1) onto the UBC1319AA00

as shown in Figure 2.

6. You can now mount the UBC1319AA00 onto the wall using

the screws installed in Step 4.

2. Fit the 2 leg stand pieces

together with the wall mount

template as represented in the

graphic to the right.

3. Place this on the wall and use it

as a template to mark the wall

for the appropriate placement

of the screws.

4. Install the 2 sets of screws on

the wall (158 mm or 6.2 inches

apart).

NOTE: The screws should protrude

from the wall so you can ﬁt the

device between the head of the

screws and the wall. If you install

the screws in drywall, use hollow

wall anchors to ensure the unit

does not pull away from the wall

due to prolonged strain from the

cable and power connectors.

You can mount the UBC1319AA00 on a wall by following the

steps below:

1. You will need 4 round or pan head screws with the following

measurements:

Figure 1

Figure 2