UBC1329AA00 DOCSIS 3.
UBC1329AA00 Quick Installation Guide D3.1 WiFi 6 eMTA Subscriber • SAFETY NOTICES Grounding the Device: Install the cable modem to include grounding the coaxial cable to the earth as close as practical to the building entrance per ANSI/NFPA 70 and the National Electrical Code (NEC, in particular, Section 820.93, Grounding of the Outer Conductive Shield of a Coaxial Cable). The device is designed for IT power systems with phase-to-phase voltage at 120V. 2.
UBC1329AA00 Quick Installation Guide • DEVICE WALL MOUNT INSTRUCTIONS 140mm (5.51 inches) You can mount the UBC1329AA00 on a wall using the 2 mounting brackets on the side of the device. Two round or pan head screws are recommended. See the figure below for measurements. D Label Size in Millimeters (mm) A 6.65 +/- 0.35 B 1.9 +/- 0.15 C 19.0 +/- 1.2 D 4-5 Note: The screws should protrude from the wall so you can fit the device between the head of the screws and the wall.
UBC1329AA00 Quick Installation Guide • UNDERSTANDING DEVICE CONNECTIONS AND BUTTONS The rear and front panels of the UBC1329AA00 have the following connections and buttons: RESET: Use to reset the device. Take a small object like the end of a paper clip and insert it into the RESET opening. To power cycle the device, hold for less than 5 seconds. To reset to factory default settings, hold for more than 20 seconds. The UBC1329AA00 will reset and reboot.
UBC1329AA00 Quick Installation Guide • LED BEHAVIOR LED COLOR DESCRIPTION ON - Internal power-on completed successfully. POWER GREEN FLASHES - Power-on failed. Note: LED blinks briefly immediately after powering on the device. OFF - No power supplied. DS/US (downstream/ upstream) GREEN FLASHES - DS and US scans in progress. Also flashes when a firmware upgrade is in progress. ON - Locked to DS and US channels and registered OK, and when data is being passed.
UBC1329AA00 Quick Installation Guide • FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
