Preface Rugged TABLET PC User Manual
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Exploring Your T10C Tablet Before starting to set up the T10C, get familiar with the locations and purposes of controls, connectors and ports, which are illustrated in the figures below. When placed upright on the desktop, the front panel of the T10C appears as shown in below. The front side of the T10C is equipped the I/O as described below.
Camera/2 Mega-pixel (Front) The built-in camera can be used as a communication device for allowing you to capture images, record videos, and have video chats. It is 2M pixels and transmitting instant image through network for conference. Camera/5 Mega-pixel (Rear) The built-in high resolution camera can be used as a communication device for allowing you to capture images, record videos, and have video chats.
For battery capacity status: The T10C is equipped with one internal battery and one optional external battery. The battery capacity status shown below advises you, that only one internal battery is embedded with the system with fully charged, and there is no 2nd optional battery installed in the system. If the system installs both the 1st internal battery and 2nd optional battery, the illustration shown below indicates its current charging status and capacity.
For RF status: The following RF status shows you that the system is equipped with Wi‐Fi, and Bluetooth functions. If you want to close either of these functions, please refer section for how to disable it. The following signal strength shows you that the Wi‐Fi function is connecting currently, the stronger the signal strength, the more scale will show on the bar. If there is no module in the system, there will be no status scale in the following status bar.
When you press it, the brightness control panel is appeared as follows: You can click or to reduce or increase the LCD brightness. Also, you can slide the scale bar to set the brightness. Volume Control For Volume adjustment, press the Volume icon. When you press it, the Volume control panel is appeared as follows: You can click incrementally. or to reduce or increase the audio volume Also, you can slide the scale bar You can tick the Mute to set the audio volume.
Maintaining the Battery Do not expose heat or attempt to disassemble the battery, and do not place the battery in water or in a fire. Do not subject the battery to strong impact, such as a blow from a hammer, or stepping on or dropping it. Do not puncture or disassemble the battery. Do not attempt to open or service the battery. Replace only with batteries designed specifically for this product. Keep the battery out of reach of children.
discolor the finish and damage the screen.