Owners manual

8
Chapter 2: Installation airFiber
®
X User Guide
Ubiquiti Networks, Inc.
3. Connect the other end of the cable from the DATA port
to the Ethernet port labeled POE on the airFiber PoE
Adapter.
WARNING: Use only the included airFiber PoE
Adapter, Model: GP-H240-100G-4. Failure to do
so can damage the unit and void the product
warranty.
4. Connect an Ethernet cable from your network to the
Ethernet port labeled LAN on the airFiber PoE Adapter.
5. Connect the Power Cord to the power port on the
airFiber PoE Adapter. Connect the other end of the
Power Cord to a power source.
Mount the PoE Adapter (Optional)
1. Remove the Mounting Bracket from the adapter by
sliding the bracket downward.
2. Place the Mounting Bracket at the desired location and
mark the holes for the fasteners. Pre-drill the holes if
necessary, then secure the bracket to the wall using
two fasteners (not included).
3. Attach the airFiber PoE Adapter to the bracket by
aligning the four slots and tabs, and then slide the
adapter downward.