User Manual

airFiber

™

Quick Start Guide

7. Configure the Wireless Security:

a. Select the AES Key Type, HEX or ASCII.

b. For the Key field:

- HEX Enter 16 bytes (eight, 16-bit HEX values: 0-9, A-F, or

a-f). You can omit zeroes and use colons, similar to the

IPv6 format.

Note: The airFiber Configuration Interface supports

IPv6 formats excluding dotted quad and "::" (double-

colon) notation.

- ASCII Enter a combination of alphanumeric characters (0-9,

A-Z, or a-z).

8. Click Change and then click Apply.

9. By default, in-band management is disabled. To enable in-band

management:

a. Click the Network tab.

b. Check the box next to In-Band Management.

c. Change the IP Address, Netmask, and other settings to

make them compatible with your network.

Note: If In-Band Management is enabled, each airFiber

radio must have a unique IP Address. If the airFiber radios

use the same IP Address, then you may lose access to the

airFiber radios via the CONFIG and DATA ports.

d. Click Change and then click Apply.

Repeat the instructions in the airFiber Configuration section on

your other airFiber radio. After you have configured the airFiber

radios, disconnect them and move them to your installation site.