User's Manual Part 2
6
Chapter 2: Installation airFiber
®
X User Guide
Ubiquiti Networks, Inc.
Mount to an Antenna
The airFiberX radio can be mounted to the antenna(s)
listed in “Installation Requirements” on page 3.
The airFiber X Antenna (AF-5G30-S45) is shown in the
following steps:
1. Attach the airFiberX radio to the mounting bracket.
a. Align the mounting tabs on the back of the
airFiberX radio with the mounting bracket.
b. Slide the airFiberX radio down to lock it into place.
2. Attach the RF cables from the antenna feed to the RF
connectors on the airFiberX radio in this combination:
+45°to Chain 0 and -45° to Chain 1.
3. Attach the External GPS Antenna to the RF connector
labeled GPS. Then, place the magnetic External GPS
Antenna on the bracket (this is temporary; you will
mount the External GPS Antenna on the GPS Antenna
Mount at the site).
4. Attach the protective shroud.
a. Align the hash mark on the top of the shroud with
the notch on the dish antenna.
b. Rotate the shroud clockwise until it locks into place.