User Manual

Back Panel
Power
Ground
Reset
Button Description
Reset
There are two methods to reset the
EdgeRouter X SFP to factory defaults:
Runtime Reset (Recommended)
The EdgeRouter X SFP should be running after
bootup is complete. Press and hold the Reset
button for about 10 seconds until the eth4
Link LED starts flashing and then becomes
solidly lit. After a few seconds, the LED will
turn off, and the EdgeRouter X SFP will
automatically reboot.
Power-on Reset
1. Disconnect the Power Adapter from the
EdgeRouter X SFP.
2. Press and hold the Reset button while
connecting the Power Adapter to the
EdgeRouter X SFP. Keep holding the button
until the eth4 Link LED starts flashing and
then stops flashing after a few seconds.
Detail Description
Ground
The EdgeRouter X SFP is grounded through
the Power Adapter; however, you can add
optional ESD grounding for enhanced ESD
protection. The ground wire and screw with
washer are not included (recommended
screw size: M3-0.5 x 4 mm).
Power Connect the Power Adapter.