Setup guide

platform Utility should be started on the administrator PC which resides on the same
network segment as the AirOS device.
AirOS system will return to the default IP configuration (192.168.1.20/255.255.255.0)
If the Reset to defaults routine is initiated.
Spanning Tree Protocol: Multiple interconnected bridges create larger networks
using the IEEE 802.1d Spanning Tree Protocol ( STP ), which is used for finding the
shortest path within network and to eliminate loops from the topology.
If the STP is turned on, the AirOS Bridge will communicate with other network devices
by sending and receiving Bridge Protocol Data Units (BPDU). STP should be turned off
(selected by default) when the AirOS device is the only bridge on the LAN or when
there are no loops in the topology as there is no sense for the bridge to participate in
the Spanning Tree Protocol in this case.
Click Change button to save the changes.
Router Mode
AP-Router mode Network Settings
IP Address: This is the IP address to be represented by the wireless interface.
Netmask: This is used to define the host and device classification for the chosen IP
address range. 255.255.255.0 is a typical value.
Enable NAT: Network Address Translation (NAT) enables packets to be sent from the
outside world to the wireless interface IP address and then sub-routed to other client
devices residing on it's local network.