Setup guide

Enable DHCP Server: Dynamic Host Configuration Protocol (DHCP) Server assigns IP
addresses to clients who will associate to the wireless interface.
Range Start/End: This range will determine the IP addresses given out by the DHCP
server to associated client devices.
Lease Time: The IP addresses given out by the DHCP server will only be valid for the
duration specified by the lease time. Increasing the time ensure client operation
without interrupt, but could introduce potential conflicts. Lowering the lease time will
avoid potential address conflicts, but might cause more slight interruptions to client
while the acquire new IP addresses from the server.
Port Forwarding: Port forwarding allows specific ports of the WLAN IP address to be
forwarded to different IP addresses on the same network. This is useful for
applications such as FTP servers, gaming, etc. where different host systems want to be
seen using a single common IP address.
PPPoE: Point-to-Point Protocol over Ethernet (PPPoE) is a virtual private and secure
connection between two systems which enables encapsulated data transport. It is
commonly used as the medium for subscribers to connect to Internet Service
Providers.
Enable DMZ: The Demilitarized zone (DMZ) can be used as a place where services
can be placed such as Web Servers, Proxy Servers, and E-mail Servers such that these
services can still serve the local network and are at the same time isolated from it for
additional security.
MULITCAST ROUTING SETTINGS
With a multicast design, applications can send one copy of each packet and address it
to the group of computers that want to receive it. This technique addresses packets to
a group of receivers rather than to a single receiver, and it depends on the network to
forward the packets to only the networks that need to receive them
Advanced