Setup guide

Failure Count To Reboot: specify the number of ICMP “echo response” replies. If the
specified number of ICMP “echo response” packets is not received continuously, the
Ping Watchdog Tool will reboot the device.
SNMP Agent
Simple Network Monitor Protocol (SNMP) is used in network management systems to
monitor network-attached devices for conditions that warrant administrative attention.
AirOS contains an SNMP agent which allows it to communicate to SNMP manage
applications for network provisioning.
SNMP Agent provides an interface for device monitoring using the Simple Network
Management Protocol (an application layer protocol that facilitates the exchange of
management information between network devices). SNMP Agent allows network
administrators to monitor network performance, find and solve network problems. For
the purpose of equipment identification, it is always a good idea to configure SNMP
agents with contact and location information:
Enable SNMP Agent: control will enable SNMP Agent.
SNMP Community: specify SNMP community string. It is required to authenticate
access to MIB objects and functions as embedded password. The device supports a
Read-only community string that gives read access to authorized management stations
to all the objects in the MIB except the community strings, but does not allow write
access.
Contact: specify the identity or the contact who should be contacted in case a
emergency situation arise.
Location: specify the physical location of the device.
NTP Client, Web Server, Telnet Server
NTP Client: The Network Time Protocol (NTP) is a protocol for synchronizing the
clocks of computer systems over packet-switched, variable-latency data networks. It
can be used to set the AirOS internal clock.
Web Server: the following AirOS Device Web Server parameters can be set there:
Use Secure Connection (HTTPS): If checked Web server will use secure HTTPS mode.
HTTP mode is selected by default.
Secure Server Port: Web Server TCP/IP port setting while using HTTPS mode.
Server Port: Web Server TCP/IP port setting while using HTTP mode..
Telnet Server: the following AirOs Device Telnet Server parameters can be set there: