Setup guide

and click the Upload button. Close this window – cancel the upload process. After the

new firmware image is uploaded into the system, use Upgrade button to upgrade a

device:

Image:System5.jpg

Do not switch off, do not reboot and do not disconnect the device from the

power supply during the firmware upgrade process as this can damage the

device!

After clicking the Upgrade button the upgrade process starts immediately:

Close this window – close firmware upgrade window. This action will not cancel the

firmware upgrade process.

Configuration Management

PowerStation2/LiteStation2/LiteStation5 configuration is stored in plain text file. Use

the Configuration Management section controls to manage (backup, restore/update)

system configuration file:

Image:System7.jpg Backup Configuration: click Download… button to download the

current system configuration file. Upload Configuration: click Browse… button to

navigate to and select the new configuration file or specify the full path and click the

Upload button.

Use only configuration backups of the same type device - configuration backed up from

PowerStation2 suits only PowerStation2, but not LiteStation2 or LiteStation5! Behavior

may be unpredictable when mixing configurations from different type devices.

Device Maintenance

Use this section to reboot device or reset all the system parameters to factory default

values:

Image:System8.jpg Reboot: click to hard-reboot the device in the current

configuration. Any non-applied changes will be lost. Reset to Defaults: click to reset the

device to factory defaults.

Retrieved from "http://wiki.ubnt.com/wiki/index.php/AirOS"

This page was last modified 11:25, 25 July 2008. This page has been accessed 43,722

times.

•

About Ubiquiti Wiki

•

Disclaimers

•