NanoBridge Models: NB-2G18 NB-5G25
Introduction Introduction Thank you for purchasing the Ubiquiti NanoBridge™. This Quick Start Guide is designed to guide you through the installation of the NanoBridge and show you how to access the airOS™ Configuration Interface. These instructions cover the NanoBridgeM2, model: NB‑2G18, and NanoBridgeM5, model: NB‑5G25. Package Contents or Dish Reflector Feed Support M6x12 Carriage Bolt (Qty.
NanoBridge™M2/M5 Quick Start Guide Application Examples The NanoBridge mounted outdoors without the Dish Reflector installed provides outdoor to indoor coverage using the 3 dBi feed antenna only. The NanoBridge mounted outdoors with the Dish Reflector installed provides directional outdoor coverage (gain reflector dependent).
Installation Installation The installation instructions show the NanoBridgeM5; however, the same instructions apply to the NanoBridgeM2. 1. Install the Feed Support to the Dish Bracket using the four M6 Bolt with Lock Washer Assemblies. 2. Install the Dish Bracket to the Dish Reflector using the four M6x12 Carriage Bolts and four M6 Serrated Flange Nuts.
NanoBridge™M2/M5 Quick Start Guide 3. Route the Ethernet cable through the bottom hole of the Feed Support and connect it to the Ethernet port on the back of the Antenna Feed. 4. Insert the Antenna Feed into the Feed Support using the orientation shown below.
Installation 5. Wrap the Feed Support Bushing around the Ethernet cable and then push it into place in the Feed Support. 6. Attach the dish assembly to the pole using the two M6 U-Bolts, two Pole Bracket Clamps, and four M6 Serrated Flange Nuts. Note: The mounting assembly can accommodate a Ø 1.25" - 2.2" pole.
NanoBridge™M2/M5 Quick Start Guide 7. Connect the other end of the Ethernet cable from the NanoBridge to the Ethernet port labeled POE on the PoE Adapter. 8. Connect an Ethernet cable from your LAN or computer to the Ethernet port labeled LAN on the PoE Adapter. 9. Connect the Power Cord to the power port on the PoE Adapter. Connect the other end of the Power Cord to a power outlet.
Accessing airOS Accessing airOS Connect to the airOS Configuration Interface. 1. Make sure that your host machine is connected to the LAN that is connected to the device. 2. Configure the Ethernet adapter on your host system with a static IP address on the 192.168.1.x subnet (e.g., 192.168.1.100). 3. Launch your Web browser. Type http://192.168.1.20 in the address field and press enter (PC) or return (Mac). 4. The login screen will appear. Enter ubnt in the Username and Password fields.
NanoBridge™M2/M5 Quick Start Guide Ubiquiti Networks Wiki and Forum Ubiquiti Networks has an online Wiki with Manuals, Guides, and Information. It is located at wiki.ubnt.com. Another great resource is the Ubiquiti Networks Forum. You can post and view comments, questions, and answers with other forum members and Ubiquiti staff at forum.ubnt.com.
General Warranty General Warranty UBIQUITI NETWORKS, Inc (“UBIQUITI NETWORKS”) represents and warrants that the Products furnished hereunder shall be free from defects in material and workmanship for a period of one (1) year from the date of shipment by UBIQUITI NETWORKS under normal use and operation. UBIQUITI NETWORKS sole and exclusive obligation under the foregoing warranty shall be to repair or replace, at its option, any defective Product that fails during the warranty period.
NanoBridge™M2/M5 Quick Start Guide Returns In the unlikely event a defect occurs, please work through the dealer or distributor from which this product was purchased. Safety Notices 1. Read, follow, and keep these instructions. 2. Heed all warnings. 3. Only use attachments/accessories specified by the manufacturer. WARNING: Do not use this product in location that can be submerged by water. WARNING: Avoid using this product during an electrical storm.
Compliance Compliance FCC Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.
NanoBridge™M2/M5 Quick Start Guide Cet appareil est conforme à la norme RSS Industrie Canada exempts de licence norme(s). Son fonctionnement est soumis aux deux conditions suivantes: 1. Cet appareil ne peut pas provoquer d’interférences et 2. Cet appareil doit accepter toute interférence, y compris les interférences qui peuvent causer un mauvais fonctionnement du dispositif.
Compliance RoHS/WEEE Compliance Statement English European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste streams. It is your responsibility to dispose of this and other electric and electronic equipment via designated collection facilities appointed by the government or local authorities.
NanoBridge™M2/M5 Quick Start Guide Français La directive européenne 2002/96/CE exige que l’équipement sur lequel est apposé ce symbole sur le produit et/ou son emballage ne soit pas jeté avec les autres ordures ménagères. Ce symbole indique que le produit doit être éliminé dans un circuit distinct de celui pour les déchets des ménages.
Declaration of Conformity Declaration of Conformity Česky [Czech] UBIQUITI NETWORKS tímto prohla uje, e tento UBIQUITI NETWORKS device, je ve shod se základními po adavky a dal ími p íslu n mi ustanoveními sm rnice 1999/5/ES. Dansk [Danish] Undertegnede UBIQUITI NETWORKS erklærer herved, at følgende udstyr UBIQUITI NETWORKS device, overholder de væsentlige krav og øvrige relevante krav i direktiv 1999/5/EF.
NanoBridge™M2/M5 Quick Start Guide Latviski [Latvian] Ar o UBIQUITI NETWORKS deklar , ka UBIQUITI NETWORKS device, atbilst Direkt vas 1999/5/EK b tiskaj m pras b m un citiem ar to saist tajiem noteikumiem. Lietuviškai [Lithuanian] UBIQUITI NETWORKS deklaruoja, kad šis UBIQUITI NETWORKS įrenginys atitinka esminius reikalavimus ir kitas 1999/5/EB Direktyvos nuostatas.
Ubiquiti Networks Support Email: support@ubnt.com Phone (9 a.m. - 5 p.m. PST): 408-942-1153 Online Resources Wiki Page: wiki.ubnt.com Support Forum: forum.ubnt.com Downloads: downloads.ubnt.com www.ubnt.com © 2012 Ubiquiti Networks, Inc. All rights reserved.
