Precision Alignment Kit for 620 mm Dish Reflector Model: PAK-620
Introduction Thank you for purchasing the Ubiquiti Networks® Precision Alignment Kit, which is compatible with the following: • airFiber® AF‑5G30-S45 • PowerBeam™ PBE-5AC-620 • PowerBeam PBE-M5-620 • RocketDish™ RD-5G30-LW Package Contents Alignment Bracket Assembly Pole Clamps (Qty. 2) Carriage Bolts (M8x150, Qty. 4) Precision Alignment Kit for 620 mm Dish Reflector Model: PAK-620 Serrated Flange Nuts (M8, Qty. 4) Installation Requirement • 13 mm Wrench Hex Head Bolts (M8, Qty.
Hardware Overview Elevation Adjustment Screw Elevation Lever Elevation Alignment Bracket Azimuth Adjustment Screw Azimuth Alignment Bracket Alignment Bracket Assembly after Separation of Brackets
Installation The following instructions show the RD-5G30-LW; however, they also apply to other antennas that use 620 mm dish reflectors. 1. Loosen the four hex head bolts of the Alignment Bracket Assembly. 2. Lift the Elevation Alignment Bracket up and out to separate it from the Azimuth Alignment Bracket.
3. Use four Hex Head Bolts to attach the Elevation Alignment Bracket to the antenna. Ensure that the Hex Head Bolts go through the Elevation Levers on the inner sides of the Elevation Alignment Bracket. 4. Attach two Pole Clamps to the Azimuth Alignment Bracket. a. Insert four Carriage Bolts into the Azimuth Alignment Bracket. b. Slide the hole of a Pole Clamp over one bolt of each pair. c. Place one Serrated Flange Nut on each bolt.
5. Attach the Azimuth Alignment Bracket to the pole: a. Slide the slot of each Pole Clamp over the corresponding Carriage Bolt. b. Tighten the four Serrated Flange Nuts to secure the Azimuth Alignment Bracket to the pole. 6. Attach the Elevation Alignment Bracket to the Azimuth Alignment Bracket: a. Insert the four hex head bolts of the Elevation Alignment Bracket into the slots of the Azimuth Alignment Bracket. b.
. Before adjusting the azimuth and elevation angles, ensure that these eight hex head bolts are loose enough to allow movement. 8. To adjust the azimuth angle up to ±15°, turn the Azimuth Adjustment Screw until the desired angle is reached.
9. To adjust the elevation angle up to ±15°, turn the Elevation Adjustment Screw until the desired angle is reached. Elevation Adjustment Screw 10. Lock the alignment by tightening the eight hex head bolts to 25 N-m. ©2015 Ubiquiti Networks, Inc. All rights reserved. Ubiquiti, Ubiquiti Networks, the Ubiquiti U logo, the Ubiquiti beam logo, airFiber, PowerBeam, and RocketDish are trademarks or registered trademarks of Ubiquiti Networks, Inc. in the United States and in other countries.
