5-Port Power over Ethernet Managed Switch Model: TS-5-POE
Introduction Introduction Thank you for purchasing the Ubiquiti Networks™ TOUGHSwitch™ PoE, which is part of the TOUGHSwitch series: Name Model Description TOUGHSwitch PoE TS-5-POE 5-port managed switch featuring 24V PoE TOUGHSwitch PoE PRO TS-8-PRO 8-port managed switch featuring 24V/48V PoE TOUGHSwitch PoE CARRIER TS-16-CARRIER Two TOUGHSwitch PoE PROs mounted in a rack This Quick Start Guide is designed to guide you through the installation and show you how to access the Configuration Interf
TOUGHSwitch™ PoE Quick Start Guide Hardware Back Panel Grounding Slot Power Ventilation Holes Grounding Slot Front Panel Ports Management 1-5 USB Interface Management 2 Reset Description 10/100 Mbps port for management. Traffic between the Management port and numbered ports will be limited to 10/100 Mbps and, under heavy load, may cause performance degradation of the TOUGHSwitch. USB Reserved for future use.
Hardware Front Panel LEDs Power/Link Speed/Link/Act PoE Management LED Power/ Link 1-5 PoE Speed/ Link/Act State Status Off No Power/No Link Amber After bootup, the LED indicates power. After an initial link is established, the LED indicates a 10/100 Mbps connection. If the link terminates, the LED turns off until a link is re-established. If the unit reboots, the LED will again indicate power until a link is established.
TOUGHSwitch™ PoE Quick Start Guide Hardware Installation Mount the TOUGHSwitch on a wall or place it on a bench top. Note: Keep 20 mm of clearance next to the ventilation holes for adequate airflow. Installation Requirements • Drill, 6 mm drill bit, and Phillips screwdriver (wall-mounting) • For outdoor applications, shielded Category 5 (or above) cabling should be used for all wired Ethernet connections and should be grounded through the AC ground of the power supply.
Hardware Installation 4. Position the Wall-Mount Slots of the TOUGHSwitch over the screw heads on the wall. Then slide the TOUGHSwitch to the left to lock it into place. Grounding the TOUGHSwitch (Optional) The TOUGHSwitch is grounded through the Power Adapter; however, you can add optional ESD grounding for enhanced ESD protection. 1. Insert a ground wire (not included) through a corner slot. 2. Twist tie to secure the ground wire to the TOUGHSwitch. 3.
TOUGHSwitch™ PoE Quick Start Guide Connecting Power 1. Connect the power connector of the Power Adapter to the Power port of the TOUGHSwitch. 2. Connect the Power Cord to the power port on the Power Adapter. Connect the other end of the Power Cord to a power outlet.
Hardware Installation Connecting Ethernet 1. Connect an Ethernet cable from the Ethernet port of your computer to the Management port of the TOUGHSwitch. 2. Connect Ethernet cables from the Ethernet ports of your devices to the numbered ports of the TOUGHSwitch. Note: PoE is disabled by default on all numbered ports and is not available on the Management port. To enable PoE on the appropriate ports, use the Ports tab in the Configuration Interface.
TOUGHSwitch™ PoE Quick Start Guide Accessing the Configuration Interface Connect to the Configuration Interface by performing the following steps: 1. Ensure that your computer (or other host machine) is connected to the Management port on the TOUGHSwitch. Note: By default, you can configure the TOUGHSwitch via any port; however, we recommend the Management port. (Access to the Configuration Interface can be limited to the Management port only. You can configure this setting on the Device tab.) 2.
Specifications Specifications TOUGHSwitch PoE Dimensions Weight Power Input Max. Power Consumption PoE Out Voltage Range Max. PoE Wattage Per Data Port ESD Rating PoE Method Button USB Port Processor System Memory 197 x 87.5 x 27.3 mm 250 g 24VDC, 2.5A Power Adapter (Included) 60 W 22-24VDC 11.5 W 24 kV Air / 24 kV Contact Passive Reset 2.
TOUGHSwitch™ PoE Quick Start Guide Safety Notices 1. Read, follow, and keep these instructions. 2. Heed all warnings. 3. Only use attachments/accessories specified by the manufacturer. WARNING: Do not use this product in location that can be submerged by water. WARNING: Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning. Electrical Safety Information 1.
Limited Warranty Warranty Conditions The above warranty does not apply if the Product: (I) has been modified and/or altered, or an addition made thereto, except by Ubiquiti Networks, or Ubiquiti Networks’ authorized representatives, or as approved by Ubiquiti Networks in writing; (II) has been painted, rebranded or physically modified in any way; (III) has been damaged due to errors or defects in cabling; (IV) has been subjected to misuse, abuse, negligence, abnormal physical, electromagnetic or electrical
TOUGHSwitch™ PoE Quick Start Guide Limitation of Liability EXCEPT TO THE EXTENT PROHIBITED BY LOCAL LAW, IN NO EVENT WILL UBIQUITI OR ITS SUBSIDIARIES, AFFILIATES OR SUPPLIERS BE LIABLE FOR DIRECT, SPECIAL, INCIDENTAL, CONSEQUENTIAL OR OTHER DAMAGES (INCLUDING LOST PROFIT, LOST DATA, OR DOWNTIME COSTS), ARISING OUT OF THE USE, INABILITY TO USE, OR THE RESULTS OF USE OF THE PRODUCT, WHETHER BASED IN WARRANTY, CONTRACT, TORT OR OTHER LEGAL THEORY, AND WHETHER OR NOT ADVISED OF THE POSSIBILITY OF SUCH DAMAGES
Compliance Australia and New Zealand Warning: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. CE Marking CE marking on this product represents the product is in compliance with all directives that are applicable to it.
TOUGHSwitch™ PoE Quick Start Guide Español La Directiva 2002/96/CE de la UE exige que los equipos que lleven este símbolo en el propio aparato y/o en su embalaje no deben eliminarse junto con otros residuos urbanos no seleccionados. El símbolo indica que el producto en cuestión debe separarse de los residuos domésticos convencionales con vistas a su eliminación.
Declaration of Conformity Declaration of Conformity Česky [Czech] UBIQUITI NETWORKS tímto prohla uje, e tento UBIQUITI NETWORKS device, je ve shod se základními po adavky a dal ími p íslu n mi ustanoveními sm rnice 1999/5/ES. Dansk [Danish] Undertegnede UBIQUITI NETWORKS erklærer herved, at følgende udstyr UBIQUITI NETWORKS device, overholder de væsentlige krav og øvrige relevante krav i direktiv 1999/5/EF.
TOUGHSwitch™ PoE Quick Start Guide Latviski [Latvian] Ar o UBIQUITI NETWORKS deklar , ka UBIQUITI NETWORKS device, atbilst Direkt vas 1999/5/EK b tiskaj m pras b m un citiem ar to saist tajiem noteikumiem. Lietuviškai [Lithuanian] UBIQUITI NETWORKS deklaruoja, kad šis UBIQUITI NETWORKS įrenginys atitinka esminius reikalavimus ir kitas 1999/5/EB Direktyvos nuostatas.
Support support.ubnt.com Community community.ubnt.com Downloads downloads.ubnt.com www.ubnt.com © 2012-2013 Ubiquiti Networks, Inc. All rights reserved.
