Owners manual

55
UniFi® Controller User Guide
Ubiquiti Networks, Inc.
Chapter 10: UniFi Security Gateway Details
Chapter 10: UniFi Security
Gateway Details
The UniFi Security Gateway hyperlink opens the UniFi
Security Gateway’s Details window either in the Properties
tab or as a separate popup window. You can always dock
this window in the Properties tab or detach it as a separate
window.
The top of the window displays the device icon and name
(or MAC address).
Properties
The Properties tab is hidden by default. To display it, click
the properties icon. The Properties tab appears on the
right side of the Devices screen.
Information about each selected device appears as a
popup within this tab.
Close Click to close the Properties tab and client
popups.
Minimize Click to display the clients as drop-down
rows.
Each row displays the following:
• (icon) Displays the icon of the device (the icon will vary
depending on the model).
• Name/MAC Address Displays the hostname, alias, or
MAC address of the device.
• Display Click to display the device information.
• Detach Click to display the same information in a
separate popup screen that can be moved anywhere
within the browser screen.
• Close Click
to close the device popup.
Hide Click
to hide the Properties tab but allow the
device popups to remain accessible from this tab.
The upper part of the detached popup screen has three
icons:
• WAN
• LAN
• VOIP (enabled in “Settings > VoIP” on page 16)
A green icon indicates an active port, and a black icon
indicates no activity. A gray icon indicates a disabled port
(VoIP requires UniFi Controller v4.6 or higher).
There are three clickable tabs:
• “UniFi Security Gateway – Details” on page 56
• “UniFi Security Gateway – Networks” on page 56
• “UniFi Security Gateway – Configuration” on page
57
The bottom of the window has three buttons:
• Locate Click to flash the Status LED on the
Gateway and the Gateway’s icon on the Map tab so you
can locate it. The LED will flash until the Locate button is
clicked again. (The icon on the Map tab will flash three
times and stop.)
• Restart Click
to restart the Gateway.
• Upgrade If a software upgrade is available for the
Gateway, click
to install the latest UniFi
firmware on the Gateway. The Status will appear
as Upgrading until the process is complete and the
Gateway reconnects to the UniFi Controller software.