User guide

36
Chapter 9: Access Point DetailsUniFi
®
Controller User Guide
Ubiquiti Networks, Inc.
Configuration
Change device configuration settings. Click the Apply
button to save changes.
Config
Alias Enter or edit the name of the device.
Apply Click Apply to save your change.
Radio(s)
Radio (11n/b/g) or Radio (11n/a)
Channel Select a channel or keep the default setting,
Auto. You can also use the default HT20 for 20 MHz
operation or HT40 for 40 MHz operation.
Note: If the AP is part of a Zero Handoff WLAN
Group, the Channel setting is chosen for you (“Zero
Handoff” on page 9) and cannot be changed.
Tx Power By default the transmit power is set to Auto. You
can also manually select High, Medium, Low, or Custom.
• High The highest TX power available.
• Low The lowest TX power available.
• Medium Halfway between High and Low.
• Custom Custom setting that you specify.
If the AP is using an external antenna, the Antenna Gain
field will appear, allowing you to specify the gain of the
attached antenna. After applying the settings, go to
Transmit Power under Details > Radio, which always
shows EIRP, and place the mouse over it to display how
it’s calculated.
Apply Click Apply to save changes.