Manual

8
Chapter 2: Using the UniFi Controller SoftwareUniFi
®
Controller User Guide
Ubiquiti Networks, Inc.
Settings > Wireless Networks
Configure the wireless networks for each site. You can
have up to four wireless network names or SSIDs per
WLANgroup.
WLAN Group The Default WLAN group is automatically
created. To create a new WLAN group, click the button.
The Add WLAN Group screen will appear.
• Name Enter a descriptive name for the WLAN group.
• Roaming To enable Zero Handoff Roaming, select the
checkbox.
Note: The UniFi AP-AC does not support Zero
Handoff Roaming for the initial release, but it will
with a future firmware upgrade.
When you enable this option, multiple APs act as an
AP cluster, appearing as a single AP. The wireless client
detects only one AP, so it seamlessly roams from AP to
AP – there is no need to re-negotiate. The APs determine
which AP has the best connection and should serve the
client. They use multicasting to communicate so they
must be wired in the same Layer 2 domain.
Zero Handoff Roaming does not support wireless
uplinks and can only be used on a secured network. It
is also not meant for all scenarios. For example, if there
is too much load or interference, then Zero Handoff
Roaming may not be appropriate for your scenario.
Configure the following options:
- Radio Select the appropriate radio, 2G or 5G.
- Channel Select the channel that all of the APs will use
for Zero Handoff Roaming.
- Create Click Create to save changes.
- Cancel Click Cancel to discard changes.
For each WLAN group, you have two tabs:
• WLANs (see below)
• “Options” on page 9
Select the appropriate WLAN group from the WLAN Group
drop-down menu.
WLANs
Name Displays the wireless network name or SSID.
Security Displays the type of security being used on your
wireless network.
Guest Network Indicates whether or not the network is a
guest network.
Actions Click a button to perform the desired action:
• Edit Make changes to the wireless network settings. Go
to the Create or Edit a Wireless Network section below.
• Delete Delete the wireless network.
Create Add a wireless network. Go to the Create or Edit a
Wireless Network section below.
Create or Edit a Wireless Network
• Name/SSID Enter or edit the wireless network name
orSSID.
• Enabled Select the checkbox to enable the wireless
network.
• Security Select the type of security to use on your
wireless network.
- Open This option is typically only used on the guest
network. When enabled, wireless network access is
open to anyone without requiring a password.