Model: WSM5 Compliance Sheet
Modular Usage The powerful 5 GHz WISP OEM Station (model: WSM5) is designed specifically for the WISP OEM market. The transmitter must only be used with the approved antenna(s). Please refer to www.ubnt.com/products for details. The WSM5 is compatible with existing Atheros Linux drivers and is only capable of 5745-5850 MHz frequency range per the FCC/IC grant. Power and frequency limits are hardcoded into the radio card EEPROM.
Important Modular Approval Information This device is intended only for the OEM integrator under the following conditions: • The antenna must be installed such that 66 cm is maintained between the antenna and users, and • The transmitter module may not be co-located with any other transmitter or antenna.
End Product Labeling This transmitter module is authorized only for use in devices where the antenna may be installed such that 66 cm may be maintained between the antenna and users (for example, access points, routers, wireless ADSL modems, and similar equipment).
End Product Manual Information The user manual for end users must include the following information in a prominent location: IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 66 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. www.ubnt.com © 2012 Ubiquiti Networks, Inc. All rights reserved.
WSM5 Important Operation Information FCC Part 15.247 (b)(4) (iii) – Professional Install Statement The professional installer is responsible for ensuring that the system is used exclusively for fixed, point-to-point operations. Installer Compliance Responsibility Devices must be professionally installed. Ubiquiti Networks does not allow operation outside of the approved 5745-5850 MHz frequency range.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
Industry Canada This Class A digital apparatus complies with Canadian ICES-003. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful communication. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: 3. This device may not cause interference, and 4.
Cet appareil est conforme à la norme RSS Industrie Canada exempts de licence norme(s). Son fonctionnement est soumis aux deux conditions suivantes: 1. Cet appareil ne peut pas provoquer d’interférences et 2. Cet appareil doit accepter toute interférence, y compris les interférences qui peuvent causer un mauvais fonctionnement du dispositif.
IC Requirement - RSS-GEN for Permanently Attached Antennas Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
