User Manual

Connecting the Cloud Key G2
The Cloud Key G2 must be installed with the 13-pin
connector facing up. Once docked, the LCD display
will appear in the window of the rackmount.
1. Remove the sticker from the 13-pin connector.
2. Insert the Cloud Key G2 into the docking bay
once the following three conditions are met:
a. The 13-pin connector is face up
b. The LCD screen is face forward into
the rackmount
c. There is no Ethernet cable connected
to the Cloud Key G2
Note: If you are going to use the Ethernet
port on the Cloud Key, make sure there is no
Ethernet cable connected to the rackmount.
Warning: To prevent creating a loop or other
unfavorable behavior on the network, only one
Ethernet connection should be used. Do not
use the Ethernet port on the Cloud Key G2 and
Rackmount Accessory simultaneously.