User Manual

Connecting the Cloud Key G2 Plus
When installing the Cloud Key G2 Plus, the width of
the Docking Bay must be adjusted to accommodate
the larger dimensions. To adjust the Docking Bay:
1. Press down on the Lock Tab and slide the
docking bay cover open until it locks into place.
2. Remove the sticker from the 13-pin connector on
the Cloud Key G2 Plus.
3. Insert the Cloud Key G2 Plus into the docking bay
once the following three conditions are met:
a. The 13-pin connector is face up
b. The LCD screen is face forward into
the rackmount
c. There is no Ethernet cable connected to the
Cloud Key G2 Plus
Warning: To prevent creating a loop or other
unfavorable behavior on the network, only one
Ethernet connection should be used. Do not
use the Ethernet port on the Cloud Key G2 Plus
and Rackmount Accessory simultaneously.