Technical Specs

End Product Labelling
FCC
Label and compliance information
The final end product must be labeled in a visible area with the following: “Contains FCC ID:
SWX-RC7611”. The grantee's FCC ID can be used only when all FCC compliance requirements
are met.
Information on test modes and additional testing requirements
This transmitter is tested in a standalone mobile RF exposure condition and any co-located or si-
multaneous transmission with other transmitter(s) or portable use will require a separate class II per-
missive change re-evaluation or new certification.
Additional testing, Part 15 Subpart B disclaimer
This transmitter module is tested as a subsystem and its certification does not cover the FCC Part 15
Subpart B (unintentional radiator) rule requirement applicable to the final host. The final host will
still need to be reassessed for compliance to this portion of rule requirements if applicable.
As long as all conditions above are met, further transmitter test will not be required. However, the
OEM integrator is still responsible for testing their end-product for any additional compliance re-
quirements required with this module installed.