Information Sheet

46
Appendix B: Standalone Mode UniFi Video User Guide
Ubiquiti Networks, Inc.
Camera Model Displays the model of the camera.
Mode Displays the camera mode: UniFi Video or
Standalone.
Connected To Displays the IP address of the server to
which the camera is connected.
Uptime Displays the camera’s total uptime in days, hours,
and minutes.
Video Quality
The Video Quality section is available in Standalone
mode only. This section of the Configure tab provides the
following information:
RTSP Stream Displays the current video resolution of the
RTSP stream: High (n x n), Medium (n x n), or Low(n x n).
Note: The displayed resolution for High, Medium,
and Low is hardware-dependent. The first number
indicates the vertical image height in pixels.
Bitrate Drag the slider control left or right to adjust the
RTSP streaming bitrate.
FPS Drag the slider control left or right to adjust the
frames per second.
Enable RTSP Authentication Use this option to require
a user to authenticate before allowing the user to view
an RTSP live stream from the camera. Check the box to
enable this option, then enter the Username and Password
that will be used for authentication.
RTSP URL Displays the current URL for RTSP streaming.
Width Displays the current width of the RTSP video feed.
Height Displays the current height of the RTSP video
feed.
Bitrate Displays the current bitrate of the RTSP video
feed.
FPS Displays the current frame rate of the RTSP video
feed.
Bottom of Window
The controls displayed at the bottom of the Configure tab
are used as follows:
Save Changes Click this button to save changes you have
made.
Revert Click this button to cancel any changes you have
made and restore the original settings.
Show Video Click this to scroll the window up to the live
video feed.
Network Tab
The Network tab displays network-related settings for the
camera.
Configuration Mode Used to set the camera’s IP address
configuration mode to Static or DHCP.
DHCP Fallback IP Address Use this to specify the IP
address to fall back to if Configuration Mode is set to DHCP
and no DHCP server is available.
DHCP Fallback Netmask Use this to specify the IP net
mask if Configuration Mode is set to DHCP and no DHCP
server is available.
Camera IP Address Displays the camera’s IP address.
MAC Address Displays the camera’s MAC address.
Netmask Displays the camera’s IP net mask.
Gateway Displays the gateway IP address.
Primary DNS Displays the DNS server IP address.
Secondary DNS Displays the secondary DNS server IP
address.
Received Displays how much data (in Kb) the camera has
received.
Transmitted Displays how much data (in Mb) the camera
has sent.
Save Changes Click this button to save changes you have
made.
Revert Click this button to cancel any changes you have
made and restore the original settings.
Show Video Click this to scroll the window up to the live
video feed.