User's Manual

2
Ubisense –Wideband Location System – Modular Tag V3.1
Regulatory Information for Europe
Hereby, Ubisense Limited declares that the radio equipment type Modular Tag V3.1 (UBIMOD31)
is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is
available at the following internet address:
www.ubisense.net or from:
Ubisense
St. Andrew's House
St. Andrews Road
Chesterton
Cambridge
CB4 1DL
United Kingdom
This UWB transmitter must not be installed at a fixed outdoor location or used in flying models,
aircraft and other forms of aviation.
The device uses the following frequency bands, at the output powers shown:
Radio interface
Lower frequency
(MHz)
Upper frequency
(MHz)
Output power (dBm)
2.4GHz
2401.75
2481.75
-4.9
Wideband
6201.001
7025.089
-42.3 (/MHz)
Integrators should note that when the module is integrated into other equipment the combined
device must meet all essential requirements and other relevant provisions of European Directives
for that combined equipment. See ETSI EG 203 367 for further details.
Regulatory Information for Canada
The Modular Tag V3.1 is approved under Industry Canada documents RSS-GEN, RSS-102,
RSS-210 and RSS-220 as a Modular Transmitter.
Le Modular Tag V3.1 est certifié et approuvé conforme selon les documents de l’Industrie du
Canada RSS-GEN, RSS-102, RSS-210 et RSS-220 en tant que module de transmission
(Modular Transmitter)
This device complies with ISED’s license-exempt RSSs. Operation is subject to the following two
conditions: (1) This device may not cause interference; and (2) This device must accept any
interference, including interference that may cause undesired operation of the device.
Cet appareil électronique est conforme à l'exemption de licence RSSs de l'ISED. Son utilisation
est soumise aux deux conditions suivantes: (1) Cet appareil ne doit pas causer d’interférences; et
(2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer
un fonctionnement indésirable de l'appareil.
It is the responsibility of the host product manufacturer that is installing the module in their device
that the host device is correctly labelled with the following text:
Contains IC: 8673A-MOD31