Specifications

Date:26-JULY-2020
Page: 19
12.4 Factory Default Reset: (Horizontal/Horizontal Movement + Trigger Leak Sensor 10s)
12.4.1 To remove Custos WWD without involve gateway in Exclusion / Remove device operation and WWD will reset all setting to Factory
Default Setting as below.
a. Remove the WWD from Z-Wave Network;
b. Delete the association setting;
c. Restore the configuration settings to the default.
12.4.2 To perform Factory Default Reset
i. Use Horizontal-Horizontal movement in WWD to activate Factory Default Reset processing,
ii. Trigger Built-in Water Leak Sensor for 10 seconds “Buzzer Sounds & LED flashing 5 times”
iii. Following below procedure to start Factory Default Reset function in Custos WWD
Ø Please process the Factory Default Reset Procedure again if WWD shows any error #3 / #5 /#7 with RED LED ON & Buzzer Sound.
Ø Trigger Built-in Leak Sensor
Ø
Horizontal-Horizontal Movement
Custos WWD Factory Default Reset Procedure