User's Manual

3300-Watt VHF Low Band Transmitter Chapter 3, Installation and Setup Procedures
335B, Rev. 0 3-4
Figure 3-1. 1 kW Minimum Ventilation Configuration
3.2 Unpacking the Cabinet and Trays
Note: Air conditioning and any
related heat exhaust ducts should be
in place before continuing with the
installation of the transmitter.
Thoroughly inspect the cabinet and all
other materials upon their arrival.
Axcera certifies that upon leaving our
facility the equipment was undamaged
and in proper working order. The
shipping containers should be inspected
for obvious damage that indicates rough
handling. Check for dents and scratches
or broken switches, meters, or
connectors. Any claims against in-transit
damage should be directed to the carrier.
Inform Axcera as to the extent of any
damage as soon as possible.
Remove the cabinet and the trays from
the crates and boxes. Remove the straps
that hold the cabinet to the shipping skid
and slide the cabinet from the skid.
Remove the plastic wrap and foam
protection from around the cabinet. Do
not remove any labeling or tags from any
cables or connectors; these are
identification markers that make
assembly of the transmitter much easier.
Remove the two L-brackets, mounted on
the front panel rails, which held the trays
in place during shipment. The trays are
mounted in the cabinet using Chassis
Trak cabinet slides as shown in Figure
3-2. The tray slides are on the sides of
the three VHF amplifier trays and the
VHF exciter tray. Inspect the trays for
any loose hardware or connectors,
tightening as needed.