User's Manual Part 1

CL1TC-4 400W DVB-H Transmitter Installation
Product Manual, Rev. 1 29
4 Installation
4.1 Unpacking and Inspection
E
ach transmitter is completely assembled, tested and shipped in the appropriate packaging.
Carefully unpack the transmitter and examine all shipping containers and contents for physical
damage that might have occurred during shipment. If damage occurred during shipment please
notify your freight carrier immediately.
Missing or damaged equipment not caused by the freight carrier should be directed to UBS-
Axcera Customer Support, in order to facilitate the replacement or repair of the equipment.
Be sure to check the package contents carefully for important documents and materials.
Note
Retain all shipping containers for storage or re-shipment purposes. All
materials returned under warranty must be packed in their original shipping
containers.
4.2 Installation Safety
T
he installation of the transmitter will require professional and properly trained personnel to
ensure it is installed in observance of the appropriate electrical and safety codes.
4.3 Installation Overview
The tra
nsmitter can be installed by following the basic sequence below:
• Transmitter set-up
o Check the installation surface structure, flatness and suitability
o Position the cabinet according to site drawings
• Transmitter AC power
o Connect the transmitter ground
o Connect the Mains AC
• Modulator connections
o Connect the GPS antenna to the modulator GPS input
o Connect the WAN/LAN to the modulator Ethernet port (A or B)
• RF output
o Connect the bandpass filter (customer furnished) to the HPA RF output
o Connect the transmission (or transmission line jumper) to the bandpass filter
output
NOTE: Detailed transmitter installation information can be found in the subsequent sections
of this manual.