User's Manual

Innovator CU5-1800BTD/BRD ATSC Transmitter/ Initial On Site
Regenerative Translator Turn On Procedure
Instruction Manual, Rev. 0 32
Table 11.1.9: Chassis Values Reset Ethernet User Name Set Up Screen
(BTD/BRD)
When applicable, this screen is used to reset the username/password file of the
Ethernet controller. If this operation is selected, ON, the username/password
file is erased thus allowing any user to login at administrator level.
Table 11.1.10: Chassis Values Reset Ethernet TCP Configuration Set Up Screen
(BTD/BRD)
When applicable, this screen is used to view or change the TCP/IP subnet mask
of the Ethernet controller.
Table 11.2: 8VSB Demodulator Main Set Up Menu Screen (BTD/BRD)
This is the System Set Up 8VSB Demodulator Main Sub Screen. Push the ENTER
button to access the Set Up 8VSB Demodulator submenus or push the DOWN Arrow to
view the next Set Up Main Sub Screen, which is the Set Up 8VSB Modulator Main Sub
Screen. NOTE: Refer to the description in Table 11B for how to change the values on
the following set-up screens.
Table 11.2.1: 8VSB Demodulator Channels Set Up Menu Screen (BTD/BRD)
This screen allows selection of the channel plan which can be changed to either
Off Air or Cable.
Table 11.2.2: 8VSB Demodulator Channel Select Set Up Menu Screen
(BTD/BRD)
This screen allows selection of the channel, for the channel plan selected in the
previous screen.
Table 11.3: 8VSB Modulator Main Set Up Menu Screen (BTD/BRD)
This is the System Set Up 8VSB Modulator Main Sub Screen. Push the ENTER button
to access the Set Up 8VSB Modulator submenus or push the DOWN Arrow to view the
next Set Up Main Sub Screen, which is the Set Up Upconverter Main Sub Screen.
NOTE: Refer to the description in Table 11B for how to change the values on the
following set-up screens.