User's Manual

Digital UHF Transmitter Chapter 2, System Description and
Customer Remote Connections
DT835A, Rev. 1 2-9
Figure 2-1: Exciter Remote Interface Assembly
Jack (J7) should have a dummy plug
connected to it, with a jumper
connected between pins 1 and 2, to
provide the interlock to the exciter
needed to operate the transmitter. If the
jumper is missing, the transmitter will
not switch to Operate. If remote
connections are made to the
transmitter, they should be made
through the plugs provided in the
installation material for the transmitter
and wired as indicated on the
interconnect drawing for the single UHF
exciter assembly (11056919). The
remote control interface connections for
this transmitter are shown in
Table 2-14.