User's Manual
Table Of Contents
- USER MANUAL
- CONTENTS
- Preface
- Disclaimer
- Part I Product Overview
- Part II Safety
- Part III Device Operations
- Part IV Functions of Tablet PC Software
- Part V Transporta and Storage
- Part VI Application Scenarios
- Part VII FAQs/Troubleshooti
- Part VIII Declaration of Conformity
User Manual for ADIBOT-A
44 / 50 Shenzhen UBTECH Robotics Corp Ltd.
5.3 Maintenance and Cleaning
Cautions:
1. Do not use abrasives, aerosols, liquid containing alcohol or any other liquids to clean ADIBOT-
A because of the uncertainty that whether the liquids contain flammable substances that may
damage the plastic cover of ADIBOT-A.
2. Do not use water or any other liquids to spray or drench ADIBOT-A. Keep it dry because of
the self-cleanning function of the product. Do not use irritating detergent or organic solvent to
wipe the camera lens.
3. Please only use soft microfiber sheets to clean up the dust from the camera and sensor.
4. Do not clean the reflectors behind the lamp in case of being scratched.
5. If the robot is found damaged, or with abnormal sound, or failed to operate normally, please
contact the local constumer service.
5.3.1 Cleaning the Robot
Follow the instructions below to operate safely and avoid damaging the robot:
1. Press the power button on the chassis to power off the robot.
2. Disconnect the charging cable from ADIBOT-A, and ensure that the robot is completely powered
off.
3. Check whether the lamp is damaged. If not, then move to the next steps.
4. Use a soft wet sheet to clean the outside of the robot.
5. Use a soft dry sheet to wipe dry the outside of the robot.
6. Check whether the robot has been wiped dry.
Warning
1. Please clean up the dust which affect normal operation on the camera and sensor.
2. Once a lamp is broken, ventilate the room for 20 minutes, and then dispose of the glass
fragments. In this way, the gas in the lamp will not be inhaled into human respiratory tract.