User's Manual

UBTECH AIMBOT USER MANUAL
UBTECH ROBOTICS CORP LTD
emergency.
Step 1 Activate the remote control
First, you need to start ADIBOT. After 30 seconds, the software is started; then, set
the remote control to be in the Bluetooth pairing state by ("Start" + "Continue"
simultaneously press for 3 seconds).
Step 2 Set parameters
Set the kill time "X minutes" and set the kill mode "full power/low power”.
Step 3 start operation
Start the killing mission by pressing the "Start" button, ADIBOT will start the killing
mission after the 20-second countdown ends. During the killing process, the operator can
pause, continue or terminate the task via the remote control.
During the entire operation, you can control the volume of the voice broadcast through
the "Volume" button.
"Broadcast" button can complete the broadcast of the current status of the device.
Step 4 Stop operation
The task in progress can be suspended by pressing the "Pause" button, and the
suspended task can be restarted by the "Continue" button.
For emergencies, you can completely stop the ongoing task by pressing the "Stop"
button. At this time, the task cannot be continued and a new killing task needs to be
restarted.
Part 5 Transporting, Clean and Storage
5.1 Transportation
If you need to transport ADIBOT, please put it in the box.
Remarks: The lamps are shipped separately, and the subsequent supplier will directly
ship to the customer or the customer to purchase by themselves.