User's Manual

UBTECH AIMBOT USER MANUAL
UBTECH ROBOTICS CORP LTD
ADIBOT 无法启动
- 检查底盘电源插口是否松动异常；
- 检查底盘开关机按键是否松动异
常；
-如果问题仍然存在，请联系 AIMBOT
技术支持中心。
设备地盘过烫
-如果地盘太烫且您无法触摸它，这
可能是由故障引起的。
-请迅速从插座断开，并联系 ADIBOT
技术支持中心。
Part 7 Declaration of Conformity
7.1 FCC compliance statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the follo
wing two conditions: (1) this device may not cause harmful interference, and (2) this devi
ce must accept any interference received, including interference that may cause undesire
d operation.
Changes or modifications not expressly approved by the party responsible for compli
ance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B dig
ital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide re
asonable protection against harmful interference in a residential installation. This equipm
ent generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communicat
ions. However, there is no guarantee that interference will not occur in a particular installa
tion.
If this equipment does cause harmful interference to radio or television reception, wh
ich can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
--
Connect the equipment into an outlet on a circuit different from that to which the receiver i
s connected.
-- Consult the dealer or an experienced radio/TV technician for help.