User's Manual

UBTECH AIMBOT USER MANUAL
UBTECH ROBOTICS CORP LTD
UVC Emitter Equipment
Emergency Stop
Electrical Device
DO NOT ENTER, UVC light can harm eyes and skin
Do NOT push on tower. Use the halo handle only.
Do NOT touch the lamp. Only certified personnel allowed.
Warning Sign
System Cooling
Part 3 Device System Operation
ADIBOT should be used as a supplement rather than a substitute for sanitation and
sanitation. Normal cleaning and disinfection could be carried out before using UV
disinfection, and then follow the steps below to deploy UV disinfection:
Step 1 After completing the basic cleaning and finishing, you can deploy ADIBOT's
disinfecting system;
NOTE: Remove the object or paper to ensure that the place or object that needs to be
disinfected can be exposed to ultraviolet light Under the light.
NOTE: If the home in the room moves, you need to move ADIBOT for a round of
disinfecting.
Step 2 Place the device at the designated location in the room, place the access card
at the door and turn it on;
NOTE: Ensure that the EMERGENCY STOP button is not pressed before activation.
IMPORTANT: If the operator does not exit the room to be disinfected within 20
seconds, the device will detect people and cause the disinfecting task to fail to start. At this
time, the operator should restart the disinfecting task.
During the disinfecting process, the “XXXX access control card” should be placed in
a place where people can see it to prevent people from entering the site to be disinfected.