User's Manual

• At least 4M bytes of hard disk space for Driver and Pen Utilities installation
• At least 4M bytes of RAM (8M bytes recommended)
• For Pressure Sensitivity: Microsoft Windows 95, 98, ME, NT, or 2000
(supported through a Wintab-compatible interface)
• For Annotate for Word: Pentium II 233 MHz or equivalent and above, at
least 48M bytes of RAM, and Microsoft Word in Office 97 or Office 2000
• For RS232C Interface: An available RS232C port (also known as serial port
or COM port) with associated available IRQ
• For USB Interface: A USB port and Windows 98, ME, or 2000
Note: At most one Pen Device may be attached to a PC at one time
Parts of a Pen Device
The key parts of a Pen Device are Pen, Tablet Plate and an optional Cordless
Mouse. Tablet Plate may be stand-alone or be embedded in another device such as a
keyboard; and the Pen may be connected to Tablet Plate with a cord (corded), or be
free from it (cordless). The figure below uses a Pen Tablet with USB interface as an
example to show the key parts of a Pen Device.
Figure 1 Parts of a Pen Device
Note: The optional Cordless Mouse requires a Pen Tablet with USB Interface.
Installing Hardware
To install the Pen Device,