User's Manual

REBOOT / - BUTTON RESET

To manually reboot UCLEAR devices, use the 3-button

reset (does not erase your settings).

Press & hold POWER + UP + DOWN at the same for a

few seconds.

Afterwards, power the unit back on. If the unit does

not power on, try resetting again while it is plugged

into its charger.

If you experience further problems, please contact

UCLEAR Support.

WHY & WHEN:

If UCLEAR device does not power on after charging or

firmware update- may be stuck in “update mode”.

LED does not light up while charging.

*NOTE: 3-Button reset is a clearing/reboot

process. It will NOT reset your U CLEAR device

to factory defaults, or erase settings or pairings.