Model: K0072 Smart Bluetooth Robot Car Kit User Guide
Smart Bluetooth Robot Car Kit User Guide
Smart Bluetooth Robot Car Kit User Guide Wheel 4 pieces Ultrasonic bracket 1 piece M3*30 socket screws 2 bars M3*6 socket screws 6 bars Ultrasonic module 1 piece Battery container 1 piece Servo accessory 1 set M3*30 round head screws 8 bars Motor drive board 1 piece Servo 1 piece T-type fastener 8 pieces M2 nuts 2 pieces M3 nuts 16 pieces UNO R3 board for Arduino 1 piece Deceleration DC motor 4 pieces 18650 Battery 2 pieces M2*10 round head screws 2 bars M3*6 round head screws 6 bars Line tr
Smart Bluetooth Robot Car Kit User Guide 1 DC motors installation Step 1: Place the DC motor in the position marked on the chassis * For example, the Front L and Front R marks should be matched between the motor and chassis Step 2: Install the DC motor M3*30 round head screws * 48 xx DC motors 8 x M3 nuts 1 x Chassis 8 x T-type fasteners
Smart Bluetooth Robot Car Kit User Guide Step 3: Repeat the above steps
Smart Bluetooth Robot Car Kit User Guide 2 Tire installation * 4 x Tires
Smart Bluetooth Robot Car Kit User Guide 3 Driver controller boards installation Step 1: Install Arduino UNO R3 * 4 x M3 nuts 4 x M3*6 socket screws 4 x M3*6 round head screws 1 x UNO R3 board for Arduino Step 2: Install motor driver board * 1 x L293D motor drive expansion board
Smart Bluetooth Robot Car Kit User Guide Step 3: Install Bluetooth module * 1 x HC-05 Bluetooth module
Smart Bluetooth Robot Car Kit User Guide 4 Battery container installation * 2 x M3 nuts 1 x Battery container 2 x M3*6 socket screws 2 x M3*5*4 countersunk head screws
Smart Bluetooth Robot Car Kit User Guide 5 Pan servo installation Step 1: Mount the Pan servo * 1 x Servo 2 x M2 nuts 2 x M2*10 round head screws Step 2: Mount the accessory of the Pan servo * 1 x Servo accessory 1 x M2*4 micro servo screw 2 x M2*8 micro servo self-tapping screws 1 x Holder for HC-SR04 Ultrasonic Module
Smart Bluetooth Robot Car Kit User Guide Step 3: Ultrasonic Module installation * 1 x HC-SR04 Ultrasonic Module
Smart Bluetooth Robot Car Kit User Guide 6 Mounting the tracking module * 2 x M3 nuts 1 x Tracking module 2 x M3*30 socket screws 2 x M3*6 round head screws
Smart Bluetooth Robot Car Kit User Guide 7 Servo wiring Connect the cables in the orientation shown in the illustration * below.
Smart Bluetooth Robot Car Kit User Guide 9 Ultrasonic module wiring * 20cm 4-Pin cable 10 Battery container wiring ----
Smart Bluetooth Robot Car Kit User Guide 11 DC motors wiring J2 connector for Front DC motors J1 connector for Rear DC motors
Smart Bluetooth Robot Car Kit User Guide After nishing installing and wiring, please insert two 18650 batteries, push the button in the front of the motor board and wait 5 seconds for the car to work. That is not all for this car kit.
