Quick Start Guide

FCC Note

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interferencein a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

● Reorient or relocate the receiving a ntenna.

● Increase the separation between the equipment and receiver.

● Connect the equipment into an outlet on a circuit different from that to which

thereceiver is connected.

WARNING: Changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to

operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may

cause undesired operation.

The equipment may generate or use radio frequency energy. Changes or modifications to

this equipment may cause harmful interference unless the modifications are expressly

approved in the instruction manual. Modifications not authorized by the manufacturer may

void user’s authorityto operate this device.

1) Switching sequence. At first, turn on the power of the transmitter, then turn on

the power of the drone. After the end, turn off the power of the drone first, and

then turn off the power of the transmitter.

2) Improper operation caused the crash. It is necessary to check and confirm the

connection of the motor, blade or electric pool of the drone and the damage

degree, so that the drone can fly again. If it is damaged, please replace it with

new accessories, otherwise it will easily cause flight accidents.

3) Battery must be removed when the drone is not in use.

Attention