User manual

UDOO Starting manual (beta) Version 0.4
http://www.udoo.org/
18"
DRAM: 1 GB
MMC: FSL_USDHC: 0,FSL_USDHC: 1,FSL_USDHC: 2,FSL_USDHC: 3
In: serial
Out: serial
Err: serial
Net: got MAC address from IIM: 00:00:00:00:00:00
FEC0 [PRIME]
Hit any key to stop autoboot: 3
Hit any key to stop autoboot: 2
Hit any key to stop autoboot: 1
Before the counter reaches 0, press any key on the external PC’ s serial console.
The booting procedure will now stop and it is possible to use the u-boot console
i.Mx6Q_UDOO_BOOT> _
Close the serial monitor and unplug J18 jumper.
This will allow the communication with the programming port of SAM3X8E.
processor without problem.
This procedure is needed since the Linux kernel enables the i.Mx6 serial port, so it is
necessary to stop its configuration before the kernel starts.