Specifications

DSD 700 OPERATING INSTRUCTIONS 23
Information
The Information Menu has three sub-menus, DSD Status, CA Status
and Loader Status, which provide important diagnostic and version
information to technical personnel. These status screen are read-only
screens. You may be asked to read some of this information to Hot Line
personnel.
To view the information do the following:
DSD Status
1 Press MENU on the RCU.
The Main Menu options list is displayed.
2 On the RCU, press to highlight Advanced Options.
3 Press OK.
The Advanced Options Menu is displayed.
4 Press to highlight Information.
5 Press OK.
The Information Menu is displayed, in which the DSD Status
option is highlighted.
6 Press OK. The DSD Status screen is displayed
7 To exit the DSD Status information screen, press EXIT to return
to the previous menu or MENU to return to the service.
CA Status
1 Repeat steps 1 to 5 of the DSD Status screen.
2 Press to highlight CA Status.
3 Press OK. The CA Status screen is displayed.
4 To exit the CA Status information screen, press EXIT to return to
the previous menu or MENU to return to the service.
Loader Status
1 Repeat steps 1 to 5 of the DSD Status screen.
2 Press to highlight Loader Status.
3 Press OK.
The Loader Status screen is displayed.
4 To exit the Loader Status information screen, press EXIT to
return to the previous menu or MENU to return to the service.
TV Installation
TV Type
Typical values are PAL I, PAL B, PAL G, PAL B/G, etc. The TV type is
determined by the TV system used in the country of installation (de-
fault is PAL BG).
To set the TV Type:
1 Press MENU on the RCU.
The Main Menu options list is displayed.
2 On the RCU, press to highlight Advanced Options.
3 Press OK.
The Advanced Options Menu is displayed.
4 Press to highlight TV Installation.
5 Press OK.
A security check screen is displayed, in which you must enter
the installation PIN (9949).
The TV Type option is automatically highlighted when the
correct PIN is entered.
6 Press OK. A TV type list is displayed in which PAL BG is
highlighted. Press to highlight any other TV type.
7 Press OK to activate the setting and leave the screen, or EXIT
to cancel the setting.
Aspect Ratio
The Aspect Ratio allows the user to select between a normal width
TV and a wide-screen TV.
1 Repeat steps 1 to 5 for setting the TV Type (page 23).
2 Press to highlight Aspect Ratio.
3 Press OK.
The Aspect Ratio screen is displayed, in which the 4:3 aspect
is highlighted.
4 Press to select the 16:9 aspect ratio (4:3 is for normal TV,
16:9 for wide-screen TV).
5 Store the setting by pressing OK on the RCU.
UHF Tuning
The UHF Tuning application allows the user to select a particular
UHF channel for satellite viewing.
1 Repeat steps 1 to 5 for setting the TV Type (page 23).
2 Press to highlight UHF Tuning.
3 Press OK. The UHF Tuning screen is displayed and the
decoder front panel display shows the current UHF channel
number.
4 Press or to increase or decrease the channel number.
If the channel number is changed, the TV picture is lost
because the TV is not tuned to the new channel. The
changed channel number is displayed on the decoder front
panel.
5 Store the setting by pressing OK on the RCU.
6 Press MENU to exit from the menu.
7 Retune the TV set to the new decoder UHF channel.
TIP: Pressing and holding down UHF (not in menu, Information Bar
or EPG mode) also causes the UHF Tuning screen to be
displayed.
NOTE: Pressing EXIT at any time while this screen is
displayed will return you to the service without
saving any changes made.