Specifications

26 OPERATING INSTRUCTIONS DSD 700
TROUBLESHOOTING
Decoder
Front Panel
Message/Display on
TV Screen or Symptom
Possible Cause
Remedies
Any menu is displayed
Normal operation. The decoder
is in menu mode
Press the MENU button on the
remote to return to normal viewing
Blank display
Blank screen (TV switched
on)
No mains power to the decoder
Ensure that the mains lead to the
decoder and mains power point is
securely plugged into the mains
outlet, and that the mains is
switched on
Small green dot
Blank screen (TV switched
on)
Normal operation. The decoder
is in standby mode
Press on the remote to return
to return to normal viewing
No small flashing
green dot when
any button on the
remote is pressed
Any display
Remote control does not work
Check that remote batteries are
correctly inserted.
Replace batteries and re-try
No Audio/Noisy Audio
PAL setting incorrect
Restore correct TV type for
country of operation
Any programme
number
Terrestrial programme
displayed
Incorrect TV channel selected
to view the satellite decoder
On the TV, select the channel
allocated to view the decoder
programmes
Incomplete video recording
- a portion of the recorded
satellite programme has not
recorded
The decoder has been switched
to standby or to a different
service during the recording
Do not make any adjustments
or selections with the remote
during recordings
Interrupted video recording.
Menus or other text appear
on the recorded satellite
programme, or the sound
level fluctuates
A button has been pressed on
the remote
Do not make any adjustments
or selections with the remote
during recordings
Blank display
Security check screen
followed by programme
blocking menu
Incorrect PIN number entered
Refer to Programme Blocking
in this manual. If you have
forgotten your PIN code
consult your service provider
Any programme
number
Programme at incorrect
programme blocking level
Programme blocking level
set incorrectly
Refer to Parental Guidance
section
3 flashing dashes
and error dot (red)
TV picture breaks up and
eventually NO SIGNAL
banner displayed
Heavy thunderstorm in progress
either locally or at transmission
point
Wait until storm subsides
Any programme
number
No audio or video
SCART functionality incorrectly
set
Press UHF button on remote to
obtain IRD on front panel display
3 flashing dashes
and error dot (red)
NO SIGNAL
or
SEARCHING FOR SIGNAL
AT XXXX MHZ
Faulty installation
Signal problem
Heavy rain (normal operation will
resume as soon as the rain
subsides
Check, repair or replace cables
Check decoder installation settings
Realign the dish
Call the service provider
Error dot (red) E03 CA module failure
The CAM is malfunctioning
Call the service provider
NOTE: The recording of any
channel is subject to copyright
laws