INSTRUCTION MANUAL CD200 1-800-547-5740 • Fax: (503) 643-6322 www.ueitest.com • email: info@ueitest.
Introduction International Symbols The CD200 has a long, slim gooseneck probe and a bright LED tip light to find leaks in tight areas.
Instructions The CD200 runs through a one-minute warm-up and self-zeroing sequence when it is first turned on in fresh air.
Replacing the Batteries Replace your 1.5 volt AA alkaline batteries when: • The green READY light begins to strobe (flash on and off) • No light or other activity occurs upon turning the instrument on If I See This Malfunction Instrument does not turn on Instrument does not tic after it is switched on, but lights work Earphone jack To replace the batteries: 1. Lay the instrument face-down on a clean, flat surface. 2. Remove the battery cover.
Gasses Detected The CD200 detects a wide variety of gasses, including some toxic gasses, and nuisance vapors. The following lists represents only a portion of the more common gasses it will detect. Combustible: Alcohol Thinners Volatile jet fuel Butane Propane Methane Other: Acetone ammonia Smoke CD200-MAN Gasoline Solvents Combustible Refrigerants Natural Gas Naphtha Acetylene Hydrogen Sulfide Steam P.
CD200 Combustible Gas Leak Detector Limited Warranty The CD200 is warranted to be free from defects in materials and workmanship for a period of three years from the date of purchase. If within the warra n ty period your instrument should become inoperative from such defects, the unit will be repaired or replaced at UEi’s option.