User Manual

151
when it returns to the zero pose.
The robotic arm should be back to the zero pose
before packaging.
1.5.9 Speed Setting
It is used to adjust the motion speed of the live control interface of
xArm. (Note that the maximum speed of the live control interface is not
the actual maximum motion speed of the robotic arm. If you want the
program to run at high speed, you can add a speed command in the
Blockly motion program).
Joint Operating Speed
● The range is 1°/s ~ 180°/s. When the robotic arm is in operation, the
actual maximum speed will be influenced by the payload, speed, and
the pose, and the maximum speed would not be an absolutely
reachable value.
Note: the speed at which the joint runs between each command is not
continuous, and the robotic arm will have a brief pause between joint
command.