User Manual

2.4.3.3. Communicate with other Machines or PLCs

If general GND (0V) is established and the machine uses open-drain

output technology, digital I/O and other can be used device

communication, see the figure below.

2.4.4. General Analog I/O

This type of interface can be used to set or measure voltage (0-10V)

going into or out of other devices.

For the highest accuracy, the following instructions are recommended:

• Use the GND terminal closest to this I/O.

• The device and Control box use the same ground (GND). The analog

I/O is not isolated from the control box.

• Use shielded cables or twisted pairs. Connect the shield to the

“GND” terminal on the “Power” section.