User guide

Compact Illuminator Range
5
INSTALLATION GUIDE (Continued)
Verify that the supporting structure can safely bear the weight of all installed units,
cables and any other equipment. The minimum thickness of the mounting surface
must be no less than 19mm.
For horizontal mounting, it is recommended that the illuminator is secured to a solid
surface using 4 x M4 or M5 screws or bolts and the keyhole slots. This is particularly
important if the illuminator location is not at ground floor level.
To mount the illuminator vertically, first securely install 4 x M4 or M5 screws or bolts
at the required distances so that they will line up with the keyhole slots. The
illuminator can then be mounted onto them and slid into position. The bolts or
screws MUST then be fully tightened.
To mount the illuminator under a surface, first securely install 4 x M4 or M5 screws or
bolts at the required distances so that they will line up with the keyhole slots. The
illuminator can then be mounted onto them and slid into position. The bolts or
screws MUST then be fully tightened.
It is recommended that a gap of 200mm (8") or more is le around the unit. This is to
allow air to circulate and prevent overheating. The location must have free
ventilation.
CLEARANCE / VENTILATION