Installation Guide

Allow the wood to acclimate for several days
prior to installation in the room in which it will be
installed. Variances in temperature and moisture
between the storage and application areas have
a negative effect on the finished appearance if
the product doesn’t adjust to room conditions
prior to installation. As wood dries, a slight joint
may open up. It is recommended to paint the
surface behind the wood a dark color.
Nail directly to the wall framing when installing in
a horizontal orientation. For applications where
vertical orientation is desired, full-length furring
strips must be installed 24 inches on center.
Use standard or painted trim nails (15 or 16
gauge). Fastener length should be long enough
for 1 1/4"-1 1/2" of penetration into solid wood.
Two nails should be placed approx. 1" from
each edge on 5.5" wide boards and ½"- ¾" on
3.5" wide boards. Two nails per connection
should be always be used.
When installing over plaster or hardboard, the
walls need to be in moderately good condition.
Construction adhesive is usually the easiest and
fastest way to install wood over drywall, plaster,
hardboard and even old shiplap. When applying
adhesive, be sure to follow the manufacturer’s
instructions. Nails should still be used to ensure
boards stay in place while the adhesive dries.
Install Boards horizontally or vertically. For horizontal
applications, start with the bottom course and work up.
Due to natural characteristics of wood, boards may
expand and contract over time. Ensure boards are
installed properly conditioned to the environment
to minimize the movement.
15- or 16-gauge
trim nails. Nail
1/2” to 1" from
bottom of board
(depending on
board width).
15- or 16-gauge trim nails
Charred Wood
board
Framing studs
Drywall over studs
Horizontal Installation
15- or 16-gauge
trim nails. Nail
1/2” to 1” from
edge of board
(depending on
board width).
15- or 16-gauge
trim nails
Framing
stud
Drywall
over studs
Vertical Installation
Furring strip
Charred Wood
board
Charred Wood trim
(install with 15- or
16-gauge trim nails
through the face
of the board)
Furring strip
This brochure is for illustration purposes only.
Use of this product must be in accordance with all local
zoning and/or building codes. Consumer assumes all risks
and liability associated with the use of this product.
Warrantor does not provide any warranty, either express
or implied, and shall not be liable for any damages,
including consequential damages.
© 2017 Universal Forest Products, Inc.
All rights reserved.
The tree logo is a registered trademark
of Universal Forest Products, Inc.
9560 12/17
CHARRED WOOD INSTALLATION INSTRUCTIONS
If using for furniture or in high traffic areas a high
quality polyurethane sealer is recommended.