Installation Guide

Install shiplap horizontally or vertically. For horizontal applications, start with
the bottom course and work up with overlap pointing downward. Do not nail
through overlaps. Shiplap siding is tight-fitting, so butt the courses up close.
© 2023 UFP Industries, Inc. All rights reserved. UFP-Edge is a trademark of UFP Retail Solutions 11303 09/23
Interior Installation
• When installing Thermally Modified Wood on the interior of the home,
it is not necessary to install over “batten strips” or rainscreen.
NOTE: (For non end-matched/8-foot length boards) Prior to installation
and for best results, check for square and trim all uneven board ends.
• The boards should be fastened in a similar fashion to interior wall studs.
Adhesive may be used to reduce the need for fasteners.
Exterior Installation Vertical Diagrams
Install shiplap horizontally or vertically. For horizontal applications, start with
the bottom course and work up with overlap pointing downward. Do not nail
through overlaps. Shiplap siding is tight-fitting, so butt the courses up close.
THIS BROCHURE IS FOR ILLUSTRATION PURPOSES ONLY. USE OF THIS PRODUCT MUST BE IN ACCORDANCE WITH ALL
LOCAL ZONING AND/OR BUILDING CODES. CONSUMER ASSUMES ALL RISKS AND LIABILITY ASSOCIATED WITH
THE USE OF THIS PRODUCT. WARRANTOR DOES NOT PROVIDE ANY WARRANTY, EITHER EXPRESS OR IMPLIED,
AND SHALL NOT BE LIABLE FOR ANY DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES.