User's Manual

Insert the RP-SMA connector of the antenna feeder
Connect ethenet cable if needed
Connect to 12V-DC power adapter (in packet) or power the device by USB Type-C adapter (not in
the packet).
Configure network and connect App with hotspot
Open the uGWAN Hotspot App in your phone, register to enter, and select "Add Hotspot".
Select uGW800-serier hotspot, you can read the network configuration instructions first, or select
"Skip" to operate step by step according to the prompts on the page.
Power on hotspot and insert a pin into the configuration hole (at the bottom of the device), press
and hold the button for 5 seconds, the hotspot's LED turn to blue (may flickering).
If you use Wi-Fi connection, select the Wi-Fi network in APP and enter password, then APP will
send the configuration to the device.
If you use Ethernet connection, select "Use Ethernet", make sure the network cable has connected
with the device. Please note that the Ethernet connection currently only supports automatic IP
acquisition.
Enable 'remote control' feature if user wants to check hotpspot's status and control it remotely.
At this step, the network configuration is completed, LED changes from blue to either yellow or
green.
9. Installation guide
uGW800 hotspot support both indoor and outdoor installation: