MSDS

MATERIAL SAFETY DATA SHEET
PRODUCT NAME: ZAR WOOD PATCH – ALL COLORS HMIS CODES: H F R P
PRODUCT CODE: 304, 309,310, 314 1 0 0
SECTION 1 – MANUFACTURER IDENTIFICATON
MANUFACTURE’S NAME: UNITED GILSONITE LABORATORIES EMERGENCY PHONE: [phone]
ADDRESS: 1396 JEFFERSON AVENUE
SCRANTON, PA 18509 INFORMATION PHONE: [phone]
NAME OF PREPARER: R. BARAKO
DATE REVISED: APRIL 2013
SUPERSEDES: JUNE 2010
SECTION II – HAZARDOUS INGREDIENTS/SARA III INFORMATION
OCCUPATIONAL EXPOSURE LIMITS VAPOR PRESSURE WEIGHT
HAZARDOUS COMPONENTS CAS NUMBER OSHA PEL ACGIH TLV OTHER mmHg@TEMP PERCENT
WATER 7732-18-5 NOT ESTAB NOT ESTAB NOT ESTAB 1.0 (68F) 23
CALCIUM CARBONATE 1317-65-3 5MG/M
3
(RESP) 2 MG/M
3
(RESP) NOT ESTAB N/A 48
POLYVINYL ACETATE RESIN 9003-20-7 NOT ESTAB NOT ESTAB NOT ESTAB N/A 5
NEPHELINE SYENITE 37244-96-5 5 MG/M
3
(RESP) NOT ESTAB 10 MG/M
3
(TWA) N/A 16
MICA 12001-26-2 3 MG/M
3
(RESP) 3 MG/M
3
(RESP) NOT ESTAB N/A 3
YELLOW IRON OXIDE 51274-00-1 10 PPM 5 MG/M
3
NOT ESTAB N/A 1
BURNT UMBER 12713-03-0 NOT ESTAB 10 MG/M
3
NOT ESTAB N/A 1
BLACK IRON OXIDE 1317-61-9 NOT ESTAB NOT ESTAB NOT ESTAB N/A 1
RED IRON OXIDE 1309-37-1 NOT ESTAB 10 MG/M
3
NOT ESTAB N/A 1
STODDARD SOLVENT 8052-41-3 100 PPM 100 PPM 100 PPM 3.0 (68F) 1
No toxic chemical (s) subject to the reporting requirements of Section 313 of Title III and of CFR 372 are present
SECTION III – PHYSICAL/CHEMCIAL CHARACTERISTICS
BOILING RANGE: 212 (F) SPECIFIC GRAVITY (H20 =1) 1.8
VAPOR DENSITY: HEAVIER THAN AIR EVAPORATION RATE: SLOWER THAN ETHER
COATING VOC: 0.41 LB/GAL (49 G/L)
SOLUBILITY IN WATER: SOLUBLE
APPEARANCE AND ODOR: COLOR PRODUCT SPECIFIC. TYPICAL AMINE ODOR
SECTION IV – FIRE AND EXPLOSION HAZARD DATA
FLASHPOINT: N/A METHOD USED: N/A
FLAMMABLE LIMITS IN AIR BY VOLUME: LOWER: N/A UPPER: N/A
EXTINGUISHING MEDIA: NONE KNOWN
SPECIAL FIRE FIGHTING PROCEDURES: CONTAINER MAY SWELL AND BURST DURING A FIRE DUE TO INTERNAL PRESSURE CAUSED BY
HEAT. THIS MAY CAUSE A SLIPPERY CONDITION ON FLOORS.
UNUSUAL FIRE AND EXPLOSION HAZARDS: N/A
SECTION V – REACTIVITY DATA
STABILITY: PRODUCT IS STABLE
CONDITIONS TO AVOID: TEMPERATURES BELOW 32(F) FOR STORAGE. TEMPERATURES BELOW 50(F) FOR APPLICATION.
INCOMPATIBILITY (MATERIALS TO AVOID): N/A
HAZARDOUS DECOMPOSITION OR BYPRODUCTS: N/A
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR